Markdown Cheat Sheet

# Headline 1
## Headline 2
### Headline 3

~~strike through~~

[link text](

> Quote text
***Johnny Author***

![image alt text](image url)
***Image caption, description***

Horizontal rule

Inline Code
`var name = "John Doe";`

Code block with syntax highlighting
``` codelanguage
function foo() {
  return bar;

Bulleted list
- item 1
- item 2
- item 3

Numbered list
1. item 1
2. item 2
3. item 3

Articles | Forum | Remote | Downloads | Buy License

How To Use Tenda N301 Router as External Accesspoint

by Adones Pitogo

Materials Needed:

  1. USB Gigabit Ethernet Adapter (important)

Alt Text

  1. Tenda N301 Router

Alt Text

Step 1: Reset Tenda Router

If you have already configured your router, reset it so we will start with fresh configuration. If your Tenda router has not been configured yet, you can skip this step.

To reset the router, find the button at beside the LAN ports which says WPS/RST. Press the button for about 8 seconds and release it. Wait for the router to restart.

Step 2: Connect to Tenda Router's WiFi

Using your smart phone or laptop, connect to the router's wifi SSID. Once connected, open a browser ang go type will see the quick start page of the router.

Alt Text

Step 3: Connection Type

In the quick start page, change the connection type to Dynamic IP.

Alt Text

Step 4: Change the WiFi Name

Scroll down to the bottom of the quick start page and change the WiFi Name according to your preference. Then click SAVE.

Alt Text

Step 5: Disable DHCP

After changing the wifi name, the router's wifi will disconnect. Connect again to the SSID of the router's wifi that you renamed. Then open again your browser and go to

Then go to Administration menu.

Alt Text

Then uncheck DHCP Server.

Alt Text

Click OK button. Lastly, reboot the router by clicking Reboot button.

Step 6: Connect the cables

Insert the USB LAN adapter to raspberry pi. Then insert a LAN cable from USB LAN adapter to the LAN 1 of Tenda router.

Alt Text

Step 7: Enable External Access Point

Turn on the raspberry pi and go to admin interface. Then navigate to WiFi Settings. Tick the Show Advanced Options checkbox.

Under the Antenna Type, select External Access Point. Click Save.

Alt Text

Lastly, go to Device Management and reboot the machine.

Updated Diagram - with coinslot disabler using SET pin

Using Coinslot's SET pin(TOP only) to enable/disable accepting coins

Setting Up Serial Coinslot Sensor using Arduino

Using Arduino as coin acceptor sensor

by Adones Pitogo