This is a basic guide on how to flash AdoPiSoft software into Raspberry Pi 3 Model B/B+ and have a working coin-operated wifi hotspot machine. You can also use this guide to reformat your old machine and install our latest image.
If you don't have the coin acceptor yet, you can still proceed to install the software and configure your wifi vending machine as long as you have araspberry pi,power supply(for raspberry pi) and amicro SD card. You won't be able to test the payment functionality though.
All the components listed here are also available in our Online Store.
Others
Important: The micro SD card must be of high quality. Use Sandisk Ultra or Samsung Evo
12V DC at least 1A output power supply.
This is used to power the coin acceptor. You must identify the positive and ground terminal using voltmeter.
Needed softwares:
After downloading the needed softwares, we need to flash the installer into the midro SD card using Etcher. To do so, unzip the contents ofadopisowifi.zip
Insert the micro SD card into the your computer using a card reader.
Open Etcher and click Select Image.
Then select adopisowifi-(version).img
from the zip file.
Make sure to select your micro SD card
Click the Flash!
button and wait for the process to finish.
If you encounter prompts about formatting your sd card, just click Cancel.
IMPORTANT:
Make sure you do the following before turning on the raspberry:
Note: You don't have to insert a monitor to the HDMI port.
Turn on the raspberry pi and wait for the AdoPisoWifi
WiFi network to appear, it may take a couple of minutes.
Connect to the wifi network using your laptop or smartphone. Once connected, open a browser and go to http://10.0.0.1/admin
username:admin
password:admin
(The machine is also accessible in your ethernet using its WAN IP.)
Connect all the connections base on the circuit diagram. Make sure to check the positive ang negative terminal of the 12V DC power supply for the coinslot to work properly.
Software is constantly being improved, you need to update the software after installation to get the latest features. To update the software, go to the admin settings and navigate to Device
section. Then click the Check For Updates
button at the bottom of the page. Then click for Install Updates
button.
We have a lot of users that have already created a machine using our software. Join our discussions and see what others are doing with their wifi vending machines.
Note:
Raspberry will use it's built-in wifi module to broadcast the SSID. But its signal is very weak and recommended only for testing purposes. It is best to upgrade the antenna using external access point / CPE antenna to extend the wifi range and speed of your wifi vending machine.
© Copyright AdoPiSoft. All Rights Reserved